高级检索

    曾凤, 朱以华, 李春忠, 卫钢, Linda Varadi. 镍锰共掺杂钙钛矿纳米线用作荧光粉制备橙光发光二极管[J]. 华东理工大学学报(自然科学版), 2022, 48(4): 485-493. DOI: 10.14135/j.cnki.1006-3080.20210407008
    引用本文: 曾凤, 朱以华, 李春忠, 卫钢, Linda Varadi. 镍锰共掺杂钙钛矿纳米线用作荧光粉制备橙光发光二极管[J]. 华东理工大学学报(自然科学版), 2022, 48(4): 485-493. DOI: 10.14135/j.cnki.1006-3080.20210407008
    ZENG Feng, ZHU Yihua, LI Chunzhong, WEI Gang, LINDA Varadi. Nickel-Manganese Co-Doped Perovskite Nanowires as Phosphors toward Light-Emitting Applications[J]. Journal of East China University of Science and Technology, 2022, 48(4): 485-493. DOI: 10.14135/j.cnki.1006-3080.20210407008
    Citation: ZENG Feng, ZHU Yihua, LI Chunzhong, WEI Gang, LINDA Varadi. Nickel-Manganese Co-Doped Perovskite Nanowires as Phosphors toward Light-Emitting Applications[J]. Journal of East China University of Science and Technology, 2022, 48(4): 485-493. DOI: 10.14135/j.cnki.1006-3080.20210407008

    镍锰共掺杂钙钛矿纳米线用作荧光粉制备橙光发光二极管

    Nickel-Manganese Co-Doped Perovskite Nanowires as Phosphors toward Light-Emitting Applications

    • 摘要: 采用配体辅助再沉淀法,在锰掺杂钙钛矿(CsPbxMn1-x(Cl/Br)3)纳米晶(NCs)的前体溶液中加入氯化镍,发现相比于锰掺杂钙钛矿NCs,镍锰共掺杂钙钛矿NCs的Mn2+的荧光强度增加了约100%,且形貌由接近立方块(边长14 nm)转变为纳米线(宽度为2~3 nm)。这可归因于Ni2+的加入降低了(100)表面能,充分溶解的前体得到更多晶核从而诱导生长为钙钛矿纳米线(NWs)。NWs作为荧光粉与市售紫外芯片构建了简易发光二极管器件,其强而宽的橙色荧光发射证实了所制备的Cs(PbxMnyNi1-x-y)(Cl/Br)3纳米线在发光应用中的潜力。在锰掺杂零维网络钙钛矿(Cs4PbxMn1-x(Cl/Br)6)的基础上加入氯化镍,得到了镍锰共掺杂零维网络钙钛矿NWs,验证了钙钛矿NWs生长机理,为合成新型掺杂钙钛矿NWs提供了参考。

       

      Abstract: CsPbX3 perovskite semiconductor has received extensive research attention in the past decade due to its high light absorption coefficient, adjustable fluorescence emission in the visible light range, long carrier diffusion length and relatively good defect tolerance. It can be used as high-efficiency phosphors in electroluminescence quantum yield light-emitting devices. In order to obtain a wider range of fluorescence emission, the element composition and crystal arrangement of the perovskite nanocrystals can be adjusted by ion exchange or the introduction of guest transition metal ions into the host nanocrystals, which leads to the changes of the optical, electronic and magnetic properties of the host nanocrystal. Using the ligand-assisted reprecipitation method, nickel chloride was added to the precursor solution of manganese-doped perovskite (CsPbxMn1-x(Cl/Br)3) nanocrystals (NCs). It was found that compared with the manganese-doped perovskite NCs, the Mn2+ fluorescence intensity of the nickel-manganese co-doped perovskite NCs increased by about 100%, and the morphology changed from approximate cubic block (side length~14 nm) to nanowire (width 2~3 nm). This can be attributed to the fact that the addition of nickel ions reduces the (100) surface energy, and the fully dissolved precursor gets more crystal nuclei and thereby induces the growth of perovskite nanowires. Subsequently, nanowires were used as phosphors and commercially available UV chips to construct a simple light-emitting diode device. Its strong and broad orange fluorescence emission confirmed the potential performance of the prepared Cs(PbxMnyNi1-x-y)(Cl/Br)3 nanowires in light-emitting applications. Finally, nickel chloride was added to the manganese-doped zero-dimensional networked perovskite (Cs4PbxMn1-x(Cl/Br)6), and the nickel-manganese co-doped zero-dimensional networked perovskite nanowires verified the growth mechanism of the perovskite nanowires. All the results provide a reference for the synthesis of novel doped perovskite nanowires.

       

    /

    返回文章
    返回